Supermicro SC836 — Appendix D SC836B Chassis Specifications

Appendix D: SC836B Added Features D-3 Installing Hard Drives in the Rear Drive Carriers The two 2.5" hard drives are hot-swappable and may be removed or replace without powering down the server. Note that only enterprise level hard drives are recom- mended for use in Supermicro chassis. Installing the Hard Drives in the Carrier 1. Remove the screws securing the dummy drive to the hard drive carrier and remove the dummy drive from the carrier. 2. Insert a hard drive into the carrier with the PCB side facing down and the connector end toward the rear of the carrier. 3. Allign the mounting holes in the drive with those in the carrier.

Note that there are holes in the carrier marked "SAS" or “SATA” to aid in correct installation. 4. Secure the drive to the carrier with four screws. Use the four M3 flat-head screws included in the HDD bag of your accessory box. Note that the screws used to secure the dummy drive to the tray cannot be reused to secure the hard drive. Figure D-8. Removing the Dummy Drive from the Hard Drive Carrier D-5