Supermicro SC836 — Choosing a Setup Location

Chapter 5: Rack Intallation Chapter 5 Rack Installation This chapter provides instructions for preparing and mounting your chassis in a rack. 5-1 Unpacking the System You should inspect the box the chassis was shipped in and note if it was damaged in any way. If the chassis itself shows damage, file a damage claim with the carrier who delivered it. 5-2 Preparing for Setup Decide on a suitable location for the rack unit that will hold your chassis. It should be a clean, dust-free area that is well ventilated. Avoid areas where heat, electrical noise and electromagnetic fields are generated. A nearby grounded power outlet.

is required The box your chassis was shipped in should include two sets of rail assemblies, two rail mounting brackets and the mounting screws to mount the system into the rack. Please read this chapter in its entirety before beginning the installation procedure. Choosing a Setup Location Leave at least 25 inches clearance in front of the rack to open the front door completely. Leave approximately 30 inches of clearance in the back of the rack to allow for sufficient airflow and access for servicing. It should be a restricted access location, such as a dedicated equipment room or a service closet. 5-1