SC836 Chassis Manual Front Connector and Pin Definitions #1 - #2. Activity LED Header The activity LED headers, designated JP26 and JP47, are used to indicate the activity status of each SAS drive. These activity LED headers are used by the host controller for the SATA drives that previously had no activity status output. If using a SAS drive, and for most SATA drives, these activity headers are not required.The Activity LED Header is located on the front panel. For the Activity LED Header to work properly, connect using a 10-pin LED cable. #3. MG9072 Chips The MG9072 chips are enclosure management chips that support the SES-2 controller and SES-2 protocols. #4.
Fan Connectors The 4-pin connectors, designated JP54, JP56, JP58 and JP60, provide power to the fans. See the table on the right for pin definitions. These 4-pin connectors are compatible with 3-pin and 4-pin fans. C-4 SAS Activity LED Header Pin Definitions Pin # Definition Pin # Definition 1 ACT IN#0 6 ACT IN#4 2 ACT IN#1 7 ACT IN#5 3 ACT IN#2 8 ACT IN#6 4 ACT IN#3 9 ACT IN#7 5 Ground 10 Empty SAS Activity LED Header Pin Definitions Pin # Definition Pin # Definition 1 ACT IN#8 6 ACT IN#12 2 ACT IN#9 7 ACT IN#13 3 ACT IN#10 8 ACT IN#14 4 ACT IN#11 9 ACT IN#15 5 Ground 10 Empty Fan Connectors Pin# Definition 1 Ground 2 +12V 3 Tachometer 4 No connection