SC846 Chassis User's Manual D-6 Rear Connector and Pin Definitions 1. Primary I 2 C Connector The I 2 C connector is used to monitor the power supply status and to control the fans. See the table on the right for pin definitions. 2. Backplane Main Power Connectors The 4-pin connectors, designated PWR1, PWR2, PWR3, PWR4, PWR5, and PWR6, provide power to the backplane. See the table on the right for pin definitions. 3. and 4. Primary and Secondary Expander Chips This primary and secondary expander chips allow the backplane to support dual ports, cascading, and failover. 5. EPP Ports The EPP ports are used for manufacturer diagnostic purposes only.
D-4 I2C Connector Pin Definitions Pin# Definition 1 Data 2 Ground 3 Clock 4 No Connection Backplane Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V