Chapter 4: Chassis Setup and Maintenance 1. Disconnect the power from the chassis by unplugging the power cord. Installing the Hard Drive Assembly 2. Remove the screws securing the dummy cover into the rear peripheral drive bay. This bay is located on the rear of the chassis beside the power supplies. 3. Lift the dummy cover up and out of the peripheral drive bay. 1 3 1 2 Figure 4-32. Removing the Dummy Cover from the Peripheral Drive Bay 4. Align the mounting holes in the hard drive backplane with those in the rear of the hard drive cage 5. Secure the backplane to the rear of the hard drive cage using two screws. 1 5 Figure 4-33. Installing the Backplane onto the Hard Drive Cage 4-27