Supermicro SC846X — Supermicro SC846X Chassis User's Manual (4U) – Free PDF Download

SC846X Chassis Manual C-4 Rear Connector and Pin Definitions 1-2. Primary and Secondary Expander Chips The primary and secondary expander chips allow the backplane to support dual port, cascading, and failover configurations. 3. Backplane Power Connectors The 4-pin connectors, designated PWR1 to PWR6 provide power to the backplane. See the table on the right for pin definitions. 4-5. Primary and Secondary SAS Ports The primary SAS connectors are designated J49 and J50. The secondary SAS Ports are designated J51 through J52 and are not present on EL1 single port backplanes. 6-7. Primary and Secondary UART Connectors For manufacturer's diagnostic purposes only.

The primary UART connector is designated PRI-UART and J30. The secondary UART connector is designated SEC-UART and J24 and is not present on BPN-SAS3-846EL1. 8-9. SDB Connectors These are debug connectors used for the manufacturer's diagnostic purposes only. The Primary SDB connector is designated PRI-SDB and J31. The secondary SDB connector is designated SEC-SDB and J29. (Not present on BPN-SAS3-846EL1 backplanes) 10. I 2 C Connectors The I 2 C connector. is designated EXP I2C0 and J48. 11. Management Data Port For manufacturer's use only. JP3 P_MDIO and JP4 P_MDIO are primary and secondary management data in and out.

C-4 Backplane Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V