Super Micro Computer, Inc. SC847DJ — Super Micro SC847DJ Chassis Manual PDF Download

SC847DJ Chassis Manual F-11 SC417B Cabling SAS3 I 2 C Cabling in the SC417B Chassis Use the diagram below to connect the I 2 C cabling. Ensure that the JP5 jumper on the CSE-PTJBOD-CB3 is cabled correctly according to the table below. When enabling SAS2/SAS3 functionality, use the connectors on the upper left of the CSE-PTJBOD-CB3 power board (See Page 2-4) and set the JP5 jumper as shown in the chart above. When an SC847D chassis is being used, use the connectors along the bottom edge fo the power board (See Page 2-4) and set the JP5 jumper as shown in the chart above.

CBL-CDAT-0601 BPN-SAS3-216EL1/EL2 Connected to the Primary I 2 C Connector (SMB) CBL-CDAT-0601 BPN-SAS3-216EL1/EL2 Connected to the Primary I 2 C Connector (SMB) Figure F-8. SAS3 I 2 C Cabling in the SC417B Chassis F-12 Jumper Settings Jumper Setting JP5 Pins 1-2: SAS3 setting (Default) Pins 2-3: SAS2 and SC847D setting JP1 JP2 CBL-CDAT-0601 BPN-SAS3-216EL1/EL2 Connected to the Primary I2C Connector (SMB)