SC936 Chassis Manual 3-2 Control Panel Buttons There are two push-buttons located on the front of the chassis. These are (in order from top to bottom) a reset button and a power on/off button. Power: The main power switch is used to apply or remove power from the power supply to the server system. Turning off system power with this button removes the primary power, but keeps standby power supplied to the system. Therefore, you must unplug system completely before servicing. Reset: The reset button is used to reboot the system 3-3 Control Panel LEDs The control panel located on the front of the SC936 chassis has five LEDs.
These LEDs provide you with critical information related to different parts of the system. This section explains what each LED indicates when illuminated and any corrective action you may need to take. Power: Indicates power is being supplied to the system's power supply units. This LED should normally be illuminated when the system is operating. HDD: Indicates IDE channel activity, SAS/SATA drives, or DVD-ROM drive activity when flashing. 3-2