SC936 Chassis Manual D-6 Front Connector and Pin Definitions 1. Primary and Secondary I 2 C Connectors The I 2 C connectors are used to monitor hard drive activity and status through LED. See the table on the right for pin definitions. There are four total connectors--two primary and two secondary. These connectors are optional and should only be used by qualified technicians. 2. Primary and Secondary Flash Chips The primary and secondary flash chips en hance the backplane memory. 3. Primary and Secondary Expander Chips These primary and secondary expander chips allow the backplane to support dual ports, cascading, and failover. 4.
Backplane Main Power Connectors The 4-pin connectors, designated PWR0, PWR1, PWR2, and PWR3, provide power to the backplane. See the table on the right for pin definitions. 5. EPP Ports The EPP ports are used for manufacturer diagnostic purposes only. D-4 I2C Connector Pin Definitions Pin# Definition 1 Data 2 Ground 3 Clock 4 No Connection Backplane Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V