Supermicro SC936E16-R1200B — Supermicro SC936E16-R1200B Chassis Manual: 3U Server with Hot-Swappable Drives

Appendix D: BPN-SAS-936EL Backplane Specifications D-7 Front Jumper Locations and Pin Definitions Explanation of Jumpers Connector Pins 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means Jumper 3 2 1 Setting the jumper is off the pins. *The buzzer sound indicates that a condition requiring immediate attention has occurred. The buzzer alarm is triggered by the following conditions: 1. Hard drive failure 2.

Fan failure 3. System temperature over 45є Celsius. D-7 General Jumper Settings Jumper Jumper Settings Note PRI MODE4 _ Pins 1-2 Factory setting Do not change PRI MODE5 _ Pins 2-3 Factory setting Do not change PRI BLINK _ Open Factory setting Do not change SEC MODE4 _ Pins 1-2 Factory setting Do not change SEC MODE5 _ Pins 2-3 Factory setting Do not change SEC BLINK _ Open Factory setting Do not change BUZZER ENB _ Open: Disabled Closed: Enabled Buzzer enable* FAN ALERT ENI _ _ Open: Disabled Closed: Enabled Fan alert enable