Parameter description: Pn800 function definition is shown in Figure 3 below. 0: Stop after home position return 1-x: Jump to the designated segment to run after home position return 0: Do not perform home position return in the first SvOn 1: Perform home position return in the first SvOn Invalid Parameter description: The pulse offset value that needs to be run after the home position signal is found during the home position return process. 158 SD700 Series Servo Technical Manual Pn800 Home position return acceleration and deceleration time setting ○ Address:0x800 Factory default:0 Setting range: unit: N/A Control mode:
P 0~0x0000FFFF Pn802 Zero point offset pulse value ○ Address:0x802 Factory default:0 Setting range:- unit: Control mode: P 2147483648~2147483648 command unit