9 Internal Position 9.1 The Position Control Function Code Parameter Setting Parameter description: Control mode selection. The position control function is the internal position mode, and the position command is given by the parameter. Before running the position control function, firstly, you need to set the servo drive control mode to position mode. Parameter description: internal and external position command selection. The point position control function is the internal position mode, so before selecting the position control mode, the position command source needs to be set to the internal position mode. Parameter description: electronic gear ratio molecule.
The electronic gear ratio of the servo drive is given together with the electronic gear than the denominator. 197 SD700 Series Servo Technical Manual Pn000 Control mode selection ○ Communication address: 0x000 Default: 0 Setting range: 0x0000 ~ Unit: N/A Control mode: P, S, T 0x000B Pn000 Features 0 Position control mode not 0 or not 16 Other control mode 16 EtherCAT mode Pn208 Position command source selection ○ Communication address: 0x208 Default: 0 Setting range: 0x0000~ Unit: N/A Control mode:
P 0x0001 Pn208 Function 0 Position command source selects external pulse input 1 Position command source selects internal position command input Pn204 Electronic gear ratio molecule ○ Communication address: 0x204 Default: 64 Setting range: 1~ Unit: N/A Control mode: P 1073741824 Pn206 Electronic gear ratio denominator ○ Communication address: 0x206 Default: 1 Setting range: 1~ Unit: N/A Control mode: P 1073741824