VEICHI — SD700 User Manual 20230516

Assuming that the position command segment number is POSNUM, the control word of the current position command segment is given by the function code Pn804+POSNUM*4; the current position command pulse number is given by the function code Pn806+POSNUM*4. By analogy, a total of 31 segment instruction segments are defined from function code Pn804 to Pn87E. The control word for the position command segment is given by Pn804. The lower 16 bits define the point position control mode, and the higher16 bits define the point operation parameter selection. Parameter description:

The lower 16 bits of the internal position command control word are the internal position command trajectory planning control word. Interpolation, overlap, relative / absolute, single-segment / multi-segment / speed / jump of internal position commands can be planned by the lower 16 bits of the internal position command control word. The upper 16 bits define the speed, acceleration, deceleration, and delay time of the Pr position command. The function code from Pn880 to Pn897 defines the acceleration/deceleration time, positioning speed and delay time during the operation of the Pr position command.

Pn804 low 16 bit A B C Pn804 high 16 bit D E F G H 201 SD700 Series Servo Technical Manual Pn804 Pr 1 control word ○ Communication address: 0x804 Default: 0x 00000000 Setting range: 0x0~ Unit: N/A Control mode: P 0x80000000 0 : Single segment position mod e 1 : Multi-segment position mod e 2 : Speed control mode 3: Jump mode 0 : Absolute position valu e 1 : Incremental position valu e 2 : Relative position valu e 0 : Run at a constant speed after the speedis reached 1 : Automatically run the next segment speed after the speed is reached Invalid 0 : The interrupt function is off 1: The interrupt function is on 0 : The overlapping function is off 1 : The over lapping function is on 0 :

Target speed unit: rpm 1 : Target speed unit: pps Invalid Acceleration time segment number selection Deceleration time segment number selection Position command speed segment number selection Invalid Delay time segment number selection