Parameter description: In the single-segment / multi-segment position mode, it is the position command pulse number given. In speed mode, it is the running target speed given. Note: Pay attention to the speed given unit when the speed value is given in the speed mode, and the speed unit is given by the D part of Pn804. 9.2.4 Position Command Segment Sharing Parameters The speed, acceleration/deceleration time, and delay time of the Pr position command are common parameters. Each of the Pr position command segments can select one of eight speeds, acceleration/deceleration time, and delay time as the operating parameters of the current position command segment.
The shared parameter definition is as follows: Parameter description: Internal position command acceleration/deceleration time selection. From the function code Pn880 to the function code Pn887, a total of 8 sets of internal multi-segment position acceleration/deceleration time are defined.
Control the actual internal multi-segment position, according to the part E of the position of the control command multi-segment word high 16 bit of , select Pn880 to Pn887 a parameter as an internal position command acceleration time; controlled according to an internal position multistage position The F- part of the upper 16 bits of the word selects one of Pn880 to Pn887 as the deceleration time of the internal multi-segment position command. Note:
When several different position command segments select the same acceleration /deceleration time function code, modify the acceleration/deceleration time value of the corresponding function code, and the acceleration/deceleration time of several position commands will be changed at the same time. Deceleration time setting is from 0rpm to accelerate to rated speed of the motor required. Same as Pn881 Same as Pn881 209 SD700 Series Servo Technical Manual Default: 0 Setting range: - 2^31~2^31 Unit: circle Control mode: P Pn880 Internal multi-segment position acceleration/deceleration time selection 0 ○ Communication address: 0x880 Default:100 Setting range:0~60000 Unit:N/A Control mode:
P Pn881 Internal multi-segment position acceleration/deceleration time selection 1 ○ Communication address: 0x881 Default: 200 Setting range: 0 ~ 60000 Unit: ms Control mode: P Pn882 Internal multi-segment position acceleration/deceleration time selection 2 ○ Communication address: 0x882 Default: 300 Setting range: 0 ~ 60000 Unit: ms Control mode: P Pn883 Internal multi-segment position acceleration/deceleration time selection 3 ○ Communication address: 0x883