vi - Record button operation button. It’s used to start and stop recording. vii - Collection method selection. It’s used to choose the mode of wave recording, real-time and triggered acquisition. 14.6.1 Real-Time Acquisition Real-time acquisition is displayed in real time in the form of waveforms on the servo operating conditions. Steps: a). Start: Select real-time acquisition mode, set the channel settings, as shown in the figure below, then click the record button , start recording, and the status of the icon changes to . b). Stop: click on the record button to stop recording, and the status of the icon changes to .
14.6.2 Trigger Acquisition The trigger acquisition is based on the trigger condition and the acquisition cycle and makes the servo operation status displayed in the form of a waveform. Steps: a). Select the trigger for the acquisition mode. After the data channel and trigger conditions are set, as shown in the following figure, click the record button , which triggers the start of recording. Note: After setting the trigger condition parameters, the terminal receives the trigger condition and will automatically judge according to the conditions. b). After the waveform to be triggered is received, the waveform will remain in the last state; the record button will change to . c).
If you need to trigger again, you need to start recording again. 291 SD700 Series Servo Technical Manual