Wiring requirements This product supports the wiring method in case of low voltage command. ● Terminals (P ⊕ , C, NΘ) are for connecting optional parts. Do not connect these terminals to the AC power supply. ● To protect the main circuit, it is covered separately from the surface that may come into contact with it. ● Be careful not to allow other objects to enter the terminal block wiring section. ● Do not solder when using stranded core wires. ● The tightening torque of each terminal may be different, so tighten the screws according to the specified tightening torque. Use a torque driver, torque ratchet or torque wrench.
● If using an electric tool to tighten the terminal screws, use the low speed setting otherwise the terminal screws may be damaged. ● Do not tighten the terminal screws at an angle of more than 5 degrees, otherwise the terminal screws may be damaged. 3.2 Motor Power Line Connection V7E motor 40mm flange power cable definition V7E motor 60mm/80mm flange power cable definition 42 SD700 Series Servo Technical Manual WIRE RUN LIST Specification CONN.1 Color CONN.2 CONN.3 Signal 6*0.3 U Blue 1 U V Brown 2 V W Red 3 W PE Yellow/Green 4 PE White 5 1 BAKE+ Black 6 2 BAKE-