VEICHI — SD700 User Manual 20230516

WIRE RUN LIST Specification CONN.1 CONN.2 Signal 1 1 +5V 2PX24AWG 2 2 0V 5 5 SD+ 6 6 SD- Iron shell 7 Shielding layer PE+ Encoder 110mm flange and above encoder definition B A 2 3 6 4 5 3 1 1 9 4 2 5 6 7 8 Note: 1. When welding the encoder, please pay attention to the definition of A-end and B-end pins (as shown in the table above). The encoder wire uses twisted pair shielded wire, and the shielding layers at both ends of the wire should be grounded. 2. When using the multi-turn absolute encoder, please pay attention to the positive and negative electrodes of the battery. It is recommended to use the lithium battery with rated voltage of 3.6V and rated capacity of 2.7AH.

3.4 Holding Brake Line Connection 45 SD700 Series Servo Technical Manual Pin definition Signal definition A pin number B pin number Encoder power +5V 1 1 Encoder power 0V 2 2 Absolute encoder battery BAT+ 3 3 Absolute encoder battery BAT- Serial data SD+ 4 5 4 5 Serial data SD- 6 6 PE(Shielding layer) Iron shell 7