alignment Slide the Yoke Assembly either left or right on the p u[tey Shaft u ntit the Stylus in the route r centers on the-righthand Set _afholes in the front Shelf Board. / / While holding the router Stylus Rod in place, (centeriine of righthand holes) loosen the Stylus MoUnt sets_crews and slide the mount left or r ght untd the secdnd Stylus aligns with the lefthand set of h 01es. If both of the Stylus Rods are not flush with the face of the front Shelf Board atthe sametime, the pulleys require adjustment.
/" j j/ J 0 / _J STYLUS TO BE CENTERED ON HOLES AND FLUSH AGAINST SHELF FACE Reaching under either one of the pulley cover guards with the 5/32 setscrew wrench locate the setscrew and loosen it sufficiently to allow the put ey to rotate independent of the pulley shaft, Note! Adjustment of only one pulley is necessary, either the left or the r ght pulley may be adjusted. Rol! the =Yoke Assembly back and forth on the Tracks several times. This should bring the two pulleys into unison. Check to determine if the correction was made by again placing the Stylus Rods aganst the front Shelf Board.
If some mis-aiignment is sti detected it may be necessary to gently roll the rig3thand pulley forward while sirfiultaneOusfy rolling the lefthand pulley rearward. If this worsens the rots-alignment reverse the procedure. Once the two Stylus are flush and properly spaced (centered on hotes) tighten the _)utley and Stylus Mo[mt setscrews securely. Make sure that the Tracks are again riding on the inside edge of the puJley grooves when making any pulley adjustments. I ! ! ! Finally check for free movement of the Yoke Assembly on the Tracks. If the pulleys slip on the Tracks additional cable tenston may be required. This is done by tightening the 8/32 nut at the rear of the Cable Assembly.
tf the pulley seems to bind on the Tracks the Cables may be excessively tight or the pulleys may not be riding on the inside edge of the pulley groove, if necessary, adjust accordingly. / If the Yoke Assembly does not slide freely from side to side.: lubrication of the pulley shaft may be required. Silicon spray or graphite provi0e excellent |egricat On and wil! not attract sawdust. If the: yoke assembly does not slide freely after lubrication; the. bearings may be slightly misaligned. Rap :the yoke Sharply above the bear rigs with _he beet of the hand torealign the bearings. / /