additional safety instructions for router-recreator 1. ALWAYS USE EYE PROTECTION. The operation of any cutting tool can result in foreign objects being thrown into the eyes, which can result in severe eye damage. Always wear safety goggles complying with ANSI Z87.! before commencing cutting tool operation. We recommend Wide Vision Safety Mask for use over goggles.., available at Sears retail or catalog stores. 3. KEEP HANDS CLEAR OF BITS AND WORKING AREA. 4_ KEEP ROUTER RECREATOR AND ROUTER CLEAN After every use, clean saw dust off the Recreator and Router, 2. DON'T FORCE TOOL The Recreator was designed for smooth operation, therefore, parts should never be forced to operate. NOTE:
Motors used onwood-working tools are particularly susceptible to the accumulation of sawdust and wood chips and shouid be blown out or "vacuumed" frequently to prevent interference with normal motor ventilation. Note and follow the instructions found on the WARNING label which appears on the yoke assembly. WARNING FOR YOUR OWN SAFETY 1. READ AND UNDERSTAND OWNER'S MANUAL OF ROUTER RECREATOR AND ROUTER BEFORE OPERATING MACHINE. 2. WEAR SAFETY GOGGLES AND EAR PROTECTION. 3. DO NOT WEAR GLOVES, NECKTIE, OR LOOSE CLOTHING. TIE BACK LONG HAIR. 4. EXCEPT FOR SPINDLE WORK NEVER USE A SMALLER DIA. STYLUS TiP THAN THE CUTTER. 5. BE POSITIVE YOU DO NOT RUN CUTTER INTO C-CLAMPS.
WEAR YOUR The operation of any power tool can result in foreign objects being thrown into the eyes, which can result in severe eye damage. Always wear safety goggles complying with ANSI Z87,1 (shown on Package) before commencing power tool operation. Safety Goggles are available at Sears retail or catalog stores. CONTENTS General Safety Instructions ................ 2 Additional Safety Instructions ............. 3 Introduction .. : ........................ 4 Unpacking and Checking Contents .......... 4 Getting to Know Your Router-Recreator ..... 4 Assembly .............................. 5 Base Assembly ....................... 5 Yoke Assembly .......................
7 Cable Assemblies ...................... 8 Instaliing the Router ................... 9 Installation of the Counterweight ......... 1! Installing the Pulley Guards ............. 12 Mounting Your Router-Recreator to a Stand. !2 Alignment ............................. !3 Operation ............................. 15 Genera! Operating Hints ................ 15 Three Dimensional Carving .............. 16 2O Sign Making ......................... Decorative Edging ..................... 22 Spindle Decorating ................... 23 Recommended Accessories ............... 25 26 Repair Parts ...........................