Generac 2700 PSI Pressure Washer 6. Reinstall the spray tip and in-line filter into the nozzle extension. 2. Shut off the engine and let it cool, then remove high pressure and garden hoses. Disconnect spark plug wire from spark plug. 7. Reconnect the nozzle extension to the spray gun. 8. Reconnect the water supply, turn on the water, and start the engine. 3. Empty the pump of liquids by pulling the engine recoil handle about 6 times.This should remove most of the liquid in the pump. 9. Test the pressure washer by operating with each of the Quick Connect spray tips. 4. Use Generac brand pump saver to prevent corrosion build up and freezing of pump. O–Ring Maintenance 5.
Store unit in a clean, dry area. Through the normal operation of your pressure washer, o–rings, which keep the connections of the hoses and spray gun tight and leak–free, may become worn or damaged. Protecting the Pump To protect the pump from damage caused by mineral deposits or freezing, use the Generac PumpSaver to treat pump.This prevents freeze damage and lubricates pistons and seals. Provided with your pressure washer is an O–Ring Maintenance Kit which includes replacement o-rings, rubber washer and water inlet filter. Refer to the instruction sheet provided in the kit to service your unit’s o-rings. Note that not all of the parts in the kit will be used on your unit. NOTE:
Generac PumpSaver, model number 01559, is available as an optional accessory. It is not included with the pressure washer. To remove a worn or damaged o–ring: Use a small flathead screwdriver to get underneath the o-ring and pry it off. CAUTION! You must protect your unit from freezing temperatures. Failure to do so will permanently damage your pump and render your unit inoperable. Freeze damage is not covered under warranty. ENGINE MAINTENANCE See the engine owner’s manual for instructions on how to properly maintain the engine. CAUTION! Read and follow all cautions and warnings on the PumpSaver can label.Always wear eye protection when using PumpSaver. CAUTION!
Avoid prolonged or repeated skin contact with used motor oil. Used motor oil has been shown to cause skin cancer in certain laboratory animals.Thoroughly wash exposed areas with soap and water. KEEP OUT OF REACH OF CHILDREN. DON'T POLLUTE. CONSERVE RESOURCES. RETURN USED OIL TO COLLECTION CENTERS. To use PumpSaver, make sure the pressure washer is turned off and disconnected from supply water. Read and follow all instructions and warnings given on the PumpSaver container. NOTE: PumpSaver will drip from pump after treatment and will stain wood and concrete. NOTE:
If PumpSaver is not available, draw RV antifreeze (non-alcohol) into the pump by pouring the solution into a 3-foot section of garden hose connected to inlet adapter and pulling recoil handle twice. PREPARING THE UNIT FOR STORAGE Water should not remain in the unit for long periods of time. Sediments or minerals can deposit on pump parts and “freeze” pump action. If you do not plan to use the pressure washer for more than 30 days, follow this procedure: STORING THE ENGINE See the engine owner’s manual for instructions on how to properly prepare the engine for storage. 1.
Flush detergent siphoning tube by placing the filter into a pail of clean water while running pressure washer in low pressure mode. Flush for one to two minutes. 14