Generac 2700 PSI Pressure Washer Move the choke lever to the “ Choke ” position (Figure 15). How to Use Accessory Tray Figure 15 - Choke Lever The unit is equipped with an accessory tray with places to store your nozzle extension and quick connect spray tips, and slots to hold the cleaning solution bottle and the detergent siphoning filter.There are also two hooks at the ends of the handle to hold your spray gun and high pressure hose. NOTE: The extra holes in the tray are for storing a brush and a turbo wand.The brush and turbo wand are NOT included with your pressure washer.You can buy these items as optional accessories. NOTE:
For a warm engine, be sure the choke lever is in the “ Run ” position. Grasp the unit’s handle with your left hand. Pull the starter grip lightly with your right hand until you feel some resistance, then pull briskly. Place the nozzle extension through the hole on the accessory tray, as shown in Figure 16. Figure 16 — Typical Accessory Tray Return the starter grip handle slowly. Do Not let rope “snap back” against starter. When engine starts, slowly move choke lever to the Run ” position. If engine falters, move choke lever to the Choke ” position, then to the “ Run ” position. If engine fails to start after six pulls, move choke lever to the “ Run ” position.
If engine fires, but does not continue to run, move choke lever to the “ Run ” position. NOTE: If the recoil starter is hard to pull, it may be necessary to squeeze the gun trigger to relieve internal pump pressure. How to Stop Your Pressure Washer Move variable pressure control lever to “ Stop ” position. Hang your chemical solution bottle on the “J” hook and place the detergent siphoning filter in the last slot on the left (Figure 16). Turn the fuel shut-off valve to the “ Off ” position (fully clockwise). Squeeze trigger on the spray gun to relieve pressure in the hose. Place the spray gun on the hook attached to the accessory tray on the right side of the unit (Figure 16). NOTE:
A small amount of water will squirt out when you release the pressure. Hang the high pressure hose on the hook attached to the accessory tray on the left side of the unit as shown on page 4. 9