CE ADJUSTMENTS _, ,,,....... ,, TO ADJUST HANDLE (See Figs. 16 Thru 18) Your lawn mower handle can be raised or lowered for your mowing comfort. Four (4) positions are available: high, medium high, medium low and low. Handles are shipped mounted in the medium low position. SHIPPING POSITION MEDIUM LOW MEDIUM HIGH - To change from medium low to medium high position, the upper and tower handle sections wiIl have to be turned over (See Fig. 16B). * Remove the controls and operator presence control bar from the upper handle. , Remove the starter rope guide from the lower handle. - Remove hairpin cotters. Disconnect the lower handle from the handle brackets (See Fig. 18).
, Turr the handle over and reassemble the hairpin cotters that have been removed. - Reassemble the starter rope guide. , Reassemble the controls and the operator presence con_rot bar to the upper handle. FIG. 16A FIG. 16B LOW CAUTION: The operator presence control bar must pivot freely to permit blade brake engagement when control bar is released. Do not over tighten the fasteners holding the controls to the upper handle, \ To change from medium ow to h gh position only the upper handte section witl have to be turned over (See Fig. 17A). , To change from medium low to tow position, only the lower handle section witl have to be turned over ',See Fig. !7B). ENGINE FIG. 17A FIG.
17B ENGINE SPEED LOWER HANDLE Your engine speed has been factory set. Do not attempt to increase engine speed or it may result in _ersonal injury. If you believe that the engine ts running too fast or too slow take your lawn mower to an authorized service center for repair and adjustment. CARBURETOR SQUEEZE TO REMOVE\ Your carburetor has a non-adjustable fixed main jet for mixture control. If your engine does not operate properly due to suspected carburetor problems, take your lawn mower to an authorized service center for repair and adjustment. HANDLE BRACKET HAIRPIN CLIP FIG, 18 16