ASSEMBLY i i iiiii lUU i iiiillU, UUl i i ii ii iiill TO iNSTALL CHUTE ASSEMBLY TO CHUTE FLANGE CHUTE ASSEMBLY Q Remove the chute assembly from the carton _Usinga 1/2 inch wrench or adjustable wrench, re- move the three (3) nuts, Iockwashers, flatwashers and carriage bolts from the chute flange° NUT LOCKWASHER FLATWASHER CARRIAGE BOLT ® PPlacethe chute assembly over the outside of the _chute flange so that the "A" on the chute assembly is next to the "A" on the chute flange This will al+gn ' al!
three holes correctly+ (SHOWN _.Fromthe inside of the chute flange, insert the three [(3) carriage bolts (removed earlier) through the \ ithree square holes The square part of the carnage bolls should fit into the square holes in the chute +!lange+ SQUARE HOLE IN CHUTE FLANGE CHUTt A ® .lnstall the three (3) flatwashers, !ockwashers and 'nuts (removed earlier) on the carriage bolts. t FIG. 8 : ._ ,Juu.ltl CAUTION: IF ALL THE THREE (3) CARRIAGE '_ BOLTS CANNOT BE MOUNTED, THE HOLES ARE NOT ALIGNED CORRECTLY.CHECK THE POSITION OF THE LETTER"A's" ON THE CH_JTE ASSEMBLYAND CHU_ FLANGE.
THEY MUST BE NEXT TO EACH OTHER+IF LESS THAN THREE (3) HOLES LINE UP,YOU HAVEMOUNTED THE CHUTE AS- SEMBLY INCORRECTt.YAND SNOW COULD BE DIS- CHARGED TOWARD THE OPERATOR.RE+INSTALLTHE CHUTE ASSEMBLYIF NECESSARY. t 10