Seres RAFTSM N — Seres RAFTSM N Электрический Моторный Косилка 19.5 Л.С. Руководство по эксплуатации и обслуживанию

The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glass- es or eye shields while operating your tractor or performing any adjust- ments or repairs. We recommend a wide vision safety mask over specta- cles, or standard safety glasses. HOW TO USE YOUR TRACTOR NOTE: Failure to move throttle control to slow position and allowing engine to idle before stopping may cause engine to =backfire'. Your tractor is equipped with an operator .presence sensing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

TO SET PARKING BRAKE Depress clutch/brake pedal into full =BRAKE" position and hold. Place parking brake lever in =ENGAGED" position and release pres- sure from clutch/brake pedal. Pedal should remain in =BRAKE" position. Make sure parking brake will hold trac- tor secure. •Tum ignition key to =OFF-" position and remove key. Always remove key when leaving tractor to prevent unauthorized use. Never use choke to stop engine. IMPORTANT: Leaving the ignition switch in any position other than =OFF" will cause the battery to be discharged, (dead). NOTE: Under certain conditions when tractor is standing idle with the engine run- ning, hot engine exhaust gases may cause =browning" of grass.

To eliminate this possibility, always stop engine when stopping tractor on grass areas. Choke Control Attachment Clutch Lever "Engaged" Position Throttle "Disengaged" Position ,_ CAUTION: Always stop tractor com- pletely, as described above, before leaving the operator's position; to empty grass catcher, etc. THROTTLE CONTROL Pedal'Ddve" Brake Position Always operate engine at full throttle. Operating engine at less than full throt- tle reduces the battery charging rate. Full throttle offers the best bagging and mower performance. CHOKE CONTROL "Brake" Gearshift Adjustment Position Lever Knob PosiUon Use choke control whenever you are start- ing a cold engine.

Do not use to start a warm engine. To engage choke control, pull knob out. Slowly push knob in to disengage. TO MOVE FORWARD AND BACKWARD STOPPING MOWER BLADES - To stop mower blades, move attach- men} c=lu{chswitch to =DISENGAGED" position. The direction and speed of movement is controlled by the gearshift lever. Start tractor with clutch]brake pedal depressed and gearshift lever in neutral (N) position. Move gearshift lever to desired posi- tion. To stop ground drive, depress clutch/brake pedal into full "BRAKE" position. Move motion control lever to neutral (N) position. IMPORTANT: The motion control lever GROUND DRIVE - Slowly release clutch/brake pedal to start movement.

does not return to neutral (N) position when the clutch/brake pedal is depressed. IMPORTANT: Bring tractor to a complete stop before shifting or changing gears. Failure to do so will shorten the useful life ENGINE - Movl_hrottle control to slow position. of your transaxle. 14