belowbeforelooseningcable, ffadjust- mentis necessary,proceedasfollows: With engine not running, move choke control (located on dash panel) to full choke position. Remove air cleaner cover, filter and car- then tum out (counterclockwise) 1-1/4 to 1-1/2 turns. FINAL SETTING - Start engine and allow to warm for five minutes. Make final adjustments with engine running and shift/motion control lever in neutral (N) position. With throttle control lever in slow posi- tion, hold throttle lever against idle speed screw and adjust idle speed screw to obtain 1200 to 1400 RPM.
While still holding throttle lever against idle speed screw, tum idle mixture screw in (clockwise) until engine begins to die and then turn out (counterclock- wise) until engine runs rough. Tum screw to a point midway between those two positions. Continue to hold throttle lever against idle speed screw and adjust idle speed screw to obtain 900 to 1200 RPM. Re- lease throttle lever. tddge plate to expose carburetor choke (see =AIR FILTER" in the Customer Responsibilities section of this manual). - Choke should be closed. If it is not, loosen casing clamp screw and move choke cable until choke is completely closed. Tighten casing clamp screw se- curely. Reassemble air cleaner.
TO ADJUST CARBURETOR The carburetor has been preset at the fac- tory and adjustment should not be neces- Clamp Quarter Circle ldle Speed rew Idle Mixture Screw Choke CI_ c,s,n , i Throttle Lever Idle Speed Screw Screw_ Choke Lever IdleMixture Throttle sary. However, minor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, proceed as follows: ACCELERATION TEST - Move throttle control lever from slow to fast position. If engine hesitates or dies, turn idle mixture screw out (counter- clockwise) 118 turn. Repeat test and continue to adjust, if necessary, until engine accelerates smoothly.
High speed stop is factory adjusted. Do not adjust - damage may result. IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed set- ting can be dangerous. If you think the engine-governed high speed needs adjusting, contact your nearest authorized service center/department, which has proper equipment and experience to make any necessary adjustments. In general,-tuming the mixture screw in (clockwise) decreases the supply of fuel to the engine giving a leaner fuel/sir mixture.
Turning the mixture screw out (counter- clockwise) increases the supply of fuel to the engine giving a richer fuel/air mixture. IMPORTANT: Damage to the needles and the seats in carburetor may result if screw is turned in too tight. PRELIMINARY SETTING - Be sure you have a clean air filter, and the throttle control cable and choke are adjusted properly (see above). WiffT_ngine off turn idle mixture screw in (clockwise) closing it finger tight and 27