INSERT CABLE CLIP Insert plastic cable clip into hole on the back of handle column, Push cables into clipo REMOVE TILLER FROM CRATE - Adjust handle assemby to lowest posi- tion_Be sure lock lever is tightened securely. ,, Make sure shift lever indicator is in "N" (neutral) position, ° Tilt tiller forward by lifting handle. Separate cardboard cover from leveling shield° o Rotate tiller handle to the right and pull tiller out of carton. CHECK TIRE PRESSURE The tires on your unit were overinflated at the factory for shipping purposes, Correct and equal tire pressure is important for best tillingperformance. o Reduce tire pressure to 20 PSI.
HANDLE HEIGHT o Handle height may be adjusted to better suit operator, (See 'q'O ADJUST HAN- DLE HEIGHT" in the Service and Adjustments section of this manual), Handle Column Cables Cable Clip CONNECT SHIFT ROD = Insert end of shift rod farthest from bend into hole of shift lever indicator° o Insert hairpin clip through hole of shift rod to secure. ° Insert other end of shift rod into hole in shift lever, ° Insert second hairpin clip through hole of shift rod. Attach this end to shift lever 0_-_... Attach this End To shift k Lever Indicator Shift Rod Shift Rod Hairpin Clip Shift Lever Indicator Shift Lever ,, i "_ ' Ha_rpLnClip Shift _, _