ASSEMBLY THIS SNOW THROWER IS EQUIPPED WITH "TRAC-PLUS" AND ONLY MOVES EFFECTIVELY WHEN ENGINE IS RUNNING if your snow thrower must be moved without the aid of the engine, it will be easier' to pull the snow thrower back- ward by the handles, rather than pushing. On start up, the track drive system may be tight and will loosen up as the snow thrower is used. After first use, check the track for tension and adjust if necessary_ See the Track Adjustment paragraph in the Service and Adjust- ments section of this manual. Check track adjustment and fasteners regularly.
CONTENTS OF SHIPPING CARTON TOOLS REQUIRED FOR ASSEMBLY 1 - Snow thrower completely assembled except for the crank assembly, shifter lever assembly and knob, and the upper handle, which is in the folded down position. 1 - Parts Bag Containing: 1 - Owner's Manual (Not Shown) Parts Shown Below: t - Knife (to cut carton and plastic ties) 2 - 1/2 inch Wrenches (or adjustable wrenches) 2 - 9/16 inch Wrenches (or adjustable wrenches) 2 - 3/4 inch Wrenches (or adjustabte wrenches) 1 - Pair Pliers (to spread cotter pin) 1 - Screwdriver PARTS BAG CONTENTS 2 - 3t8 In.Flat Washers 2 - Spare Spacers 1 - 3/8 - t6 x 2 inch Hex Head Bolt 2- 1/4 - 20 x 1 - 3/4 In.. Hex Head Bolts Q 1 - 3/8 In..
Hex Nut 1 - 3/8 tn., Split Lockwasher 2 - Spare 1/4 - 20 Locknuts 1 - Knob With Threads 6