Generac Portable Products 2,100 PSI High Pressure Washer IMPORTANT: Read entire owner’s manual before you attempt to assemble or operate your new pressure washer. PREPARING PRESSURE WASHER FOR USE REMOVE PRESSURE WASHER FROM CARTON If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at 1-800-270-1408. To prepare your pressure washer for operation, you will need to perform these tasks: Fill out and send in registration card. Attach accessory tray to handle, then attach handle to main unit. Add oil to engine crankcase. Remove the parts box included with pressure washer.
Slice two corners at the end of carton from top to bottom so the panel can be folded down flat, then remove all packing material. Roll pressure washer out of carton. Add fuel to fuel tank. Carton Contents Connect high pressure hose to spray gun and pump. Items in the carton include: Main Unit Connect water supply to pump. Parts Box (which includes the following): Attach Handle and Accessory Tray Goggles NOTE: All assembly operations given in this section will be described from the perspective of assembling the pressure washer from the rear. Handle Plastic Accessory Tray Handle Fastening Hardware Kit (which includes):
Slide the plastic accessory tray onto the handle and align the holes in the accessory tray with the holes on the handle (Figure 1). Carriage Bolts (2) Plastic Knobs (2) Figure 1 — Attach Accessory Tray “J” Hook Chemical Hose Clip Self Tapping Screws (5) Nozzle Cleaning Kit High Pressure Hose Quick Connects Owner’s Manual Engine Manual Owner’s Registration Card Spray Gun Nozzle Extension Oil Bottle O-Ring Maintenance Kit Secure tray to handle with self tapping screws using a #2 phillips screwdriver. Ensure screws are tight but not crushing the plastic accessory tray. If any of the above parts are missing or damaged, call the pressure washer helpline at 1–800–270–1408. 5