Generac Portable Products 2,100 PSI High Pressure Washer Place your left foot on the lower frame and grasp the handle as shown (Figure 15). Your unit may appear slightly different from that shown here. How to Use Accessory Tray The unit is equipped with an accessory tray with places to store your nozzle extension, and slots to hold the cleaning solution bottle and the detergent siphoning filter. There are also two hooks at the ends of the accessory tray to hold your spray gun and high pressure hose. Figure 15 — Recommended Engine Starting Posture NOTE: The extra holes in the tray are for storing a brush and a turbo wand. The brush and turbo wand are NOT included with your pressure washer.
You can buy these items as optional accessories. Place the nozzle extension through the hole on the accessory tray, as shown in Figure 16. Figure 16 — Typical Accessory Tray Pull the starter grip handle lightly with your right hand until you feel some resistance, then pull briskly. Return the starter grip handle slowly. Do Not let rope “snap back” against starter. Hang your chemical solution bottle on the “J” hook and place the detergent siphoning filter in the last slot on the left (Figure 16). When engine starts, slowly move choke lever to the Run ” position. If engine falters, move choke lever to the “ Choke ” position, then to the “ Run ” position.
Hang the high pressure hose on the hook on the right side of the accessory tray (Figure 16). If engine fails to start after six pulls, move choke lever to the “ Run ” position. If engine fires, but does not continue to run, move choke lever to the “ Choke ” position, then to the “ Run ” position. Place the spray gun on the hook on the left side of the accessory tray as shown on page 4. How to Use the Adjustable Nozzle NOTE: If the recoil starter is hard to pull, it may be necessary to squeeze the gun trigger to relieve internal pump pressure. You now should know how to START your pressure washer and how to STOP it.
The information in this section will tell you how to adjust the spray pattern and apply detergent or other cleaning chemicals. How to Stop Your Pressure Washer Move throttle lever on engine to “ Stop ” position. Squeeze trigger on the spray gun to relieve pressure in the hose. CAUTION! Never adjust spray pattern when spraying. Never put hands in front of nozzle to adjust spray pattern. NOTE: A small amount of water will squirt out when you release the pressure. The adjustable nozzle affixed to the nozzle extension permits you to adjust the spray pattern and the spray pressure, as follows: 9