Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery. TO R_MOVE CABLES, REVER_E ORDER - BLACK cable first from chassis and then from the fully charged battery. RED cable last from both batteries. Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. Close hood. INTERLOCKS AND RELAYS Loose or damaged wiring may cause your tractor to run poody, stop running, or pre- vent it from starting. Check wiring. See electrical wiring dia- gram in the Repair Parts section of this manual. TO REPLACE FUSE Replace with 30 amp automotive-type plug- in fuse. The fuse0holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEM- BLY Raise hood. -Posve_" (+)___' N_ative" (-) L.H. Panel _-_]/ / Unsnap headlight wire connector. Stand m front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor. To replace, reverse above procedures. REPLACING BA'n'ERY ACAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatcn bands rings etc. Positive term na must be connected first to prevent sparking from accidental ground- mg. Lift hood to raised position. Remove terminal guard.
Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor, Install new battery with terminals in same position as old batte_. Hood % Headlight [ Wire j Connector ENGINE Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers expense_ may be performed by any non- road engine repair establishment or individ- ual. Warranty repairs must be performed by an authodzed engine manufacturer's ser- vice outlet. TO ADJUST THROTTLE CONTROL CABLE The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable.
If adjust- ment is necessary, proceed as follows: 'o With engine not running, move throttle control lever to fast position. Check that swivel is against side of quar- ter circle: If it is not, loosen cable clamp screw and pull cable back until swivel is against quarter circle. Tighten cable clamp screw securely. TO ADJUST CHOKE CONTROL The choke control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as descdbed below before loosening cable. If adjust- ment is necessary, proceed as follows: First connect RED battery cable to posi- tive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.
Connect BLACK groundin_ cable to neg- ative (-) battery terminal with remaining hex bolt and keps nut. Tighten securely. , Close terminal access doors. Close hood. Hex Bolt Keps :Reinstall terminal guard. Terminal ..." Access Door_ : _°° (Red) Cable Terminal Guard Cable TO REPLACE HEADLIGHT BULB Raise hood. Pull bulb holder out of the hole in the backside of the grill. 25