Sep. 2001 IDENTIFYING THE VERSION fig.Load-3 NUMBER 1. Turn the power off. At this stage, even more data can be received. 2. While pressing [NAME/NS/MASTER],[UTILITY] and [MANUAL] button, turn on power. 3. Press [EXIT] button to quit Bulk Load. fig.LCD1 3. The version number is displayed. After you press [EXIT] button, “Checking...” appears in the display, indicating that the GT-6 is checking the received data. When the check is completed, the Play screen returns to the display. TEST MODE TRANSMITTING / RECEIVING * Note: When user data is present, always back it up on the sequencer (MC-80, etc.) before repair.
DATA VIA MIDI (Refer to “Saving data” and “Loading data” for the user data storage procedures). Individual inspection items The GT-6 can use exclusive messages to set another GT-6 to the same settings, or to transmit its settings to a device such as a sequencer for storage. 1.DSP Check The process of transmitting such data is called bulk dump, and the process of receiving such data is called bulk load. 2.Display 3.LCD Contrast 4.Switch 5.VR Check BULK DUMP 6.EXP PEDAL 7.Battery 1. Press [UTILITY] button, then press PARAMETER [ ] button so that “Bulk Dump” is displayed. 8.MIDI IN/OUT 9.OUTPUT D/A fig.Dump-1 10.EXT OD/DS 11.INPUT A/D 12.DSP INTO 13.Noise (IN -> OUT) 14.Noise (EXT) 2.
Press PARAMETER [ ] button to move the cursor, and rotate the [PATCH/VALUE] dial to select the start and end of the data to be transmitted. 15.Calibrete EXP 16.Factory Load Required items 3. When the data to be sent has been determined, press [WRITE] button. The data is transmitted. • Expression Pedal (Roland EV-5) fig.Dump-2 • MIDI Cable • Noise Meter • Oscilloscope • Oscillator When the transmission is completed, the screen prior to transmission returns to the display. • Equipment with digital input • Empty plug 4. Press [EXIT] button to return to the Play screen. How to enter test mode: • Starting from “1.DSP Check”.
BULK LOAD Turn on the unit while pressing the [DELAY] and [DELAY TAP] buttons simultaneously. The ROM version and the checksum will be displayed first. Proceed to “1.DSP Check” by pressing the [EXIT] button. 1. fig.Load-1 Press [UTILITY] button, then press PARAMETER [ ] button so that “Bulk Load” is displayed. fig.LCD1 • Starting from “9.OUTPUT D/A”. 2. Transmit the data from the external MIDI device. Turn on the unit while pressing the [CHORUS] and [REVERB] buttons simultaneously. fig.Load-2 The following appears in the display when the GT-6 receives the data. “1.DSP Check” result is displayed first, then it proceeds to “9.OUTPUT D/A”.
The following appears in the display when the GT-6 finishes receiving the data. 14