Right side cover To remove the right side cover from the printer 1 Open the drum drawer (top drawer) and remove the imaging drum, protecting it from light. 2 Remove the top cover. CAUTION Exposure to light for more than 15 seconds can seriously damage the imaging drum. 3 Open the ITB drawer (middle drawer) and Tray 2. 4 Remove the two screws shown in callout 1, Figure 6-4. 5 Carefully pull out the bottom of the cover, and disengage the two tabs located behind the cover (see callout 2, Figure 6-4) by sliding the cover to the rear. Lift the cover up and off.
Reinstallation tip CAUTION When reinstalling the cover, ensure that the tabs on the inside of the cover (callout 2, Figure 6-4) are seated properly by pushing in firmly on the tabs while sliding the cover forward into position. 2 1 Figure 6-4 Right side cover removal and replacement 146 Removal and replacement C7085-90921