Paper path pick-up motor (M2) Note Turn the printer off, wait five seconds, and then unplug the printer. 1 Remove the top cover. 2 Remove the left side cover. 3 Disconnect the paper path motor connector (J109) from the paper feed PCB and remove it from the cable trough. 4 Remove the two screws on both sides of the paper path motor shown in Figure 6-49. 5 Remove the paper path motor by sliding the motor back and then out to clear the gear on the motor. Figure 6-49 Paper path motor removal and replacement C7085-90921 Chapter 6 Removal and replacement 187