Rear assemblies Large right side fan To remove the large right side fan 1 Remove the formatter pan assembly. 2 Remove the four screws as shown in Figures 6-57 and 6-58, and remove the fan shield. 3 Disconnect the fan cable (J209) from the developing PCB. 4 Unweave the fan cable from the cable stays. 5 Release the plastic tabs at the top and bottom of the fan housing, and then slide the fan out. Large right side fan replacement tip Ensure that the fan cable is facing out and located in the lower corner. Figure 6-57 Large right side fan removal and replacement (1 of 2) C7085-90921 Chapter 6 Removal and replacement 195