Table 7-2 Alphabetical printer error messages (continued) FUSER LIFE LOW REPLACE KIT (4500) -or- FUSER LIFE LOW ORDER KIT (4550) Description: Approximately 95% of the fuser’s life has been consumed. Action: Continue printing, or replace the fuser kit. Fuser replacement will be required in the near future. Fuser Life Out Replace Kit Description: The fuser has reached the end of its expected life. Action: Replace the fuser kit. INITIALIZING Description: The message appears when the printer is initially turned on. Action: No action required. INSTALL DRUM KIT Description: The drum kit is not installed or is incorrectly installed. Action: Verify that the drum kit is correctly installed.
INSTALL TRAY 2 Description: The printer cannot print until media is loaded into Tray 2. The paper path for Tray 3 passes through Tray 2. Action: Insert Tray 2 into the printer so that printing from Tray 3 can continue or start. MEMORY FULL STORED DATA LOST Description: The printer has no available memory. The current job might not print correctly. Some downloaded fonts might have been deleted. Action: Try printing simplified pages. If this does not resolve the problem, add printer memory. MEMORY SETTINGS CHANGED Description: The I/O buffering settings were changed by the printer because there is not enough memory available to use the previous settings. Action: No action required.
However, adding printer memory might prevent this from occurring. MEMORY SHORTAGE JOB CLEARED Description: The available memory was not enough to continue printing. The remainder of the job was canceled. Action: No action required. However, adding printer memory might prevent this from occurring. MEMORY SHORTAGE PAGE SIMPLIFIED Description: The printer’s adaptive data compression had to resort to lossy compression to fit raster graphics in the available memory. This has caused a data loss in the raster output. Action: 1. Reduce the complexity of the page to improve the print quality. NO JOB TO CANCEL 2. Adding memory will not correct this problem. Description:
[Cancel Job] was pressed but there is no active job or buffered data to cancel. The printer automatically returns to the READY state. Action: No action required. C7085-90921 Chapter 7 Troubleshooting 221