NOTICE To supply switching devices and sensors to the screw terminal block of the device, the supply voltage is derived (pins 13 and 14 of the terminal block). If power consumption of input exceeds the load capacity of the built-in power supply (24 V), then an external power supply with an output voltage of 12 to 34 V (24 V recommended) must be used for powering. Scheme for connection of the switching devices to the inputs is shown in Figure 5.2 . Figure 5.2 – Connection of switching devices:
a) for operation with n-p-n sensors; b) for operation with p-n-p sensors Scheme for connection of passive and active sensors with an output n-p-n open-collector transistor or p-n-p is shown in Figures 5.3 and 5.4 accordingly. 22