Figure 5.5 – Scheme of connecting load to the output of type Р A transistor optocoupler is usually used to control a low-voltage relay (up to 50 V), see Figure 5.6 . CAUTION In order to avoid failure of the transistor due to the large self-induction current, it is necessary to install a VD1 diode (KD103 or similar type) in parallel to the relay coil. Figure 5.6 – Scheme of connecting load to the output of type K The optosimistor is connected to the control circuit of the power triac through the limiting resistor R1 according to the scheme shown in Figure 5.7 . 24