Removal and Installation Platen Assembly Removal WARNING Switch off the printer and remove the power cord. 1. Open the window. NOTE In the following steps, please treat the screws with great care as they can easily be damaged. 2. Remove twenty-nine screws T-10 screws (item 1) from the platen assembly (item 2) and remove the platen assembly (see Figure 68). 2 1 C607421 Figure 68: Platen Assembly Installation of the Platen Assembly CAUTION When installing the Platen Assembly, make sure the screws are installed properly so that the heads of the screws do not interfere with the media path when the printer is in use. Do not exceed a torque of 10 psi on the screws.
NOTE You must perform the following Service Calibrations after the installation of the Platen Assembly. n Carriage Height Calibration ⇒ Page 5-24 . n Service Station ⇒ Page 5-11 . n Color to Color Calibration ⇒ Page 5-16 . 8-63 HP DesignJets 1050C and 1055CM Printers Service Manual