Smart IP43 Charger Manufacturer IP43 — 6.4.1. Voltage, temperature and current sense

Smart IP43 Charger 6. After a short delay a pop-up dialog box will appear confirming that the network has been successfully configured; select OK to close the dialog box. 7. The VE.Smart network configuration details are displayed within the the VE.Smart networking page. 8. End the current Bluetooth session by exiting into the VictronConnect Device list Local page. 9. Connect the Smart IP43 Charger AC power cable to a mains power outlet; after a short delay all LEDs will illuminate briefly, then the LEDs indicating the current charge mode and charge state will illuminate. 10.

Using a Bluetooth enabled device (mobile phone or tablet), open the VictronConnect app and locate the Smart IP43 Charger (or other VE.Smart networking compatible charger) in the Device list Local page, then connect to the device (the default PIN code is stated on a label located on the side of the charger, or try 000000 if there is no label). 11. Select the Settings icon (gear in the top right corner) to access the Settings page. 12. Select VE.Smart networking to access the VE.Smart networking page. Page 41 Setup