Smart IP43 Charger Manufacturer IP43 — 6.4.2. Synchronised charging

Smart IP43 Charger 6.4.2. Synchronised charging To setup a VE.Smart Network with Synchronised charging: 1. Connect all Smart IP43 Charger AC power cables to a mains power outlet; after a short delay all LEDs will illuminate briefly, then the LEDs indicating the current charge mode and charge state will illuminate. 2. Using a Bluetooth enabled device (mobile phone or tablet), open the VictronConnect app and locate the first Smart IP43 Charger in the Device list Local page, then connect to the device the default PIN code is stated on a label located on the side of the charger, or try 000000 if there is no label). 3.

Select the Settings icon (gear in the top right corner) to access the Settings page. 4. Select VE.Smart networking to access the VE.Smart networking page. 5. Select CREATE NETWORK (or JOIN NETWORK if a VE.Smart network has already been created). 6. Enter a name to identify the VE.Smart network and select OK . 7. After a short delay a pop-up dialog box will appear confirming that the network has been successfully configured; select OK to close the dialog box. Page 44 Setup