Smart IP43 Charger 2. Quick start guide 1. The Smart IP43 Charger range is designed to be permanently mounted using the mounting flanges integrated into the heat sink. Identify/provide a suitable and safe location for the charger on a non-flammable substrate, with at least 10cm of clearance surrounding the charger and good natural airflow/ventilation; do not install or place/operate the charger on top of the battery, directly above the battery, or in a sealed compartment with the battery. Mount the Smart IP43 Charger vertically with the terminals facing down; secure using suitable pan/flange head screws though the mounting holes/slots. 2.
Connect suitable DC power cabling between the Smart IP43 Chargers BATTERY terminals (torque the terminal screws to 2.4Nm) and the battery or DC system distribution bus; all LEDs will illuminate briefly when DC power is connected. There are specific wiring connection instructions for charging a battery installed within a vehicle; refer to the 'Installation > Wiring' section for more information. 3. Connect the Smart IP43 Charger AC power cable to a mains power outlet; after a short delay all LEDs will illuminate briefly, then the LEDs indicating the current charge mode and charge state will illuminate. Page 2 Quick start guide