2 Connection and commissioning 2.4.1 Connect the probe to the probe connector 1. Hold the probe so that the lug on the probe connector faces the groove in the socket on the top of the instrument. ATTENTION Do not push in the connector by force. Check position of lug and groove. 2. Insert the probe connector straight into the probe socket all the way from the top. 3. Tighten the locking nut finger-tight. Do not use tools. Removing the probe: Loosen the locking nut and pull the probe upwards and out at the metal plug. EN 2.4.2 Connect the probe to the optical input The HP-01 and EHP-50F/G field analyzers are connected to the optical input of the FieldMan.
A suitable optical cable is included with the probes. Connecting a probe: 1. Go to GENERAL SETTINGS > CONNECTIVITY > OPTICAL INTERFACE and select Probe . 2. Connect a suitable probe via the optical cable to the optical connector on the FieldMan (see 2.2 Device overview on page 28 ). For more information on using a probe via the optical link, refer to the operating instructions for the probe. 30 FieldMan Narda