Contents Connections Playback Settings Tips Appendix Graphic EQ o Speaker Selection Uses the graphic equalizer to adjust the tone of each speaker. Select whether to adjust tones for individual speakers or for all speakers. 0 Speakers for which “Graphic EQ” can be set differ according to the sound mode. 0 This can be set when “MultEQ ® XT32” setting is “Off”. ( v p. 179) 0 This cannot be set when the sound mode is set to “Direct” or “Pure Direct”. 0 If you are using headphones, you can set the equalizer for headphones. ( v p. 182) All: Adjust all speaker tones together. Left/Right (Default) : Adjust the left and right speaker tones together. Each: Adjust the tone for each speaker.
o Graphic EQ / Headphone EQ o Adjust EQ Set whether to use the graphic equalizer or not. Adjust tonal balance for each frequency band. On: Use the graphic equalizer. 1. Select the speaker. 2. Select the adjustment frequency band. 63 Hz / 125 Hz / 250 Hz / 500 Hz / 1 kHz / 2 kHz / 4 kHz / 8 kHz / 16 kHz 3. Adjust the level. –20.0 dB – +6.0 dB (Default: 0.0 dB) Off (Default) : Do not use the graphic equalizer. 0 “Headphone EQ” is set in the menu when headphones are used. 0 Front Dolby, Surround Dolby and Back Dolby speakers can only be set when 63 Hz/125 Hz/250 Hz/500 Hz/1 kHz. Front panel Display Rear panel 182 Remote Index