Sony — Owner's Manual - Marantz

Contents Connections Playback Settings Tips Appendix Levels Crossovers Set the volume of the test tone to be the same at the listening position when it is output from each speaker. Set in accordance with the lower limit frequency of the base frequencies that can be played back through each speaker. See the speaker manual for information concerning speaker crossover frequency. o Test Tone Start A test tone is output from the selected speaker. While listening to the test tone, adjust the volume output from the selected speaker. o Set the crossover frequency 40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz / 200 Hz / 250 Hz (Default:

80 Hz) –12.0 dB – +12.0 dB (Default : 0.0 dB) 0 “Crossovers” can be set when the “Subwoofer Output” setting is “LFE + Main”, or when you have a speaker that is set to “Small”. ( v p. 230) 0 The default crossover frequency is “80 Hz”, which will work best with the widest variety of speakers. We recommend setting to a higher frequency that the crossover frequency when small speakers are used. For example, set to “250 Hz” when the frequency range of the speakers is 250 Hz – 20 kHz. 0 Sound below the crossover frequency is cut off from the output of the speakers set in “Small”. This cut off bass frequency is output from the subwoofer or front speakers.

0 The speakers that can be set differ depending on to the “Subwoofer Output” setting. ( v p. 230) 0 The set “Levels” are reflected in all sound modes. 0 If you wish to adjust the channel level for each input source, carry out the settings in “Channel Level Adjust”. ( v p. 121) 0 When headphones are connected to the PHONES connector on this unit, you cannot set “Levels”. o Set Defaults The “Levels” settings are returned to the default settings. 0 When “LFE” is selected, speakers set to “Small” at “Speaker Configuration” can be set. If the speakers are set to “Large”, “Full Band” is displayed and the setting cannot be made. ( v p.

219) 0 When “LFE + Main” is selected, speakers can be set regardless of the “Speaker Configuration” setting. ( v p. 219) 0 The audio settings in “IMAX Audio Settings” are applied during IMAX playback. ( v p. 173) Front panel Display Rear panel 229 Remote Index