Contents Connections Playback Settings Tips Appendix Tactile Transducer Setup o Low Pass Filter Set the level and low pass filter cutoff frequency when using tactile transducers. Selects the low pass filter cutoff frequency for the tactile transducer output. o Tactile Transducer 40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz / 200 Hz / 250 Hz (Default: 80 Hz) Sets the tactile transducer option. 0 The “Low Pass Filter” are reflected in all input sources. Disabled (Default) : Disables the tactile transducers. Enabled: Enables tactile transducers. 0 For Tactile Transducer connections, use the Subwoofer 4 PRE OUT connector.
0 This can not be set when “Speaker Configuration” - “Subwoofer” is set to “4 spkrs”. o Level Adjusts the volume of the tactile transducer output. –12.0 dB – +12.0 dB (Default : 0.0 dB) 0 The “Level” are reflected in all input sources. 0 If you wish to adjust the tactile transducer level for each input source, carry out the settings in “Tactile Transducer”. ( v p. 124) Front panel Display Rear panel 232 Remote Index