Contents Connections Playback Settings Tips Appendix o HDMI Audio o Volume Limit Selects the audio signal format for playing an HDMI source in ZONE2. Through (Default) : The HDMI audio signal is passed through this unit to the device in ZONE2. Make a setting for maximum volume. 60 – 80 (–20 dB – 0 dB) (Default : 70 (-10 dB)) The HDMI audio signal input into this unit is converted to a PCM signal that can be output from the ZONE2 PRE OUT connectors or speaker terminals. Off: Do not set a maximum volume. PCM: 0 This can be set when “Volume Level” is set to “Variable”. ( v p. 249) 0 The dB value is displayed when the “Scale” setting is “-79.5 dB - 18.0 dB”. ( v p.
178) o Power On Volume 0 When the same input source is set for both MAIN ZONE and ZONE2, PCM 2- channel is used for the audio in MAIN ZONE too. However, it may not be possible to convert the signal from some playback devices to a PCM signal using this setting. o Volume Level Sets the initial volume level when the power is turned on. Last (Default) : Sets the power-on level to the last-used volume level. Set the volume output level. Variable (Default) : Volume can be adjusted. Mute: Sets the power-on level to mute level. 1 – 98 (–79 dB – 18 dB): Sets a specific power-on level. 1 – 98 (–79 dB – 18 dB): Volume is fixed at the desired level.
The volume cannot be adjusting using the remote control unit. 0 This can be set when “Volume Level” is set to “Variable”. ( v p. 249) 0 The dB value is displayed when the “Scale” setting is “-79.5 dB - 18.0 dB”. ( v p. 178) 0 The dB value is displayed when the “Scale” setting is “ –79.5 dB – 18.0 dB”. ( v p. 178) Front panel Display Rear panel 249 Remote Index