Sony — Owner's Manual - Marantz

Contents Connections Playback Settings Tips Appendix 0 Set “Assign Mode” to “Preamplifier” if connecting all channels to the Pre-out connectors using an external amplifier. ( v p. 211) This stops operation of the internal power amplifier of this unit, reducing interference in the preamplifier created by the power amplifier. 0 You can use the “Speaker Connection” setting to disconnect the built-in power circuit of each channel individually and use just your favorite channel as the Preamplifier. ( v p. 231) 0 When using just one surround back speaker, connect it to the left channel (L) terminal.

0 The output signal for the PRE OUT connector of Height 1 and Height 2 vary depending on the combination of the Height/Ceiling/Dolby Atmos Enabled speakers that you are using. For the PRE OUT connector that connects each Height/Ceiling/Dolby Atmos Enabled speaker, refer to “Amp Assign” - “Layout” ( v p. 213). Front panel Display Rear panel 44 Remote Index