Contents Connections Playback Settings Tips Appendix Procedure for speaker settings (Audyssey ® Setup) 1 Attach the Sound calibration microphone to the supplied microphone stand or own tripod and install it at the main listening position. When installing the Sound calibration microphone, point the tip of the microphone toward the ceiling and adjust the height to match the height of the ears of a listener in a seated position. 2 If using a subwoofer capable of the following adjustments, set up the subwoofer as shown below.
n When using a subwoofer with a direct mode Preparation Measurement Calculation & Store Set the direct mode to “On” and disable the volume adjustment and crossover frequency setting. n When using a subwoofer without a direct mode Check Make the following settings: 0 Volume : 12 o’clock position 0 Crossover frequency : Maximum/Highest Frequency Finish 0 Standby mode : Off 0 Low pass filter : Off Front panel Display Rear panel 166 Remote Index