Contents Connections Playback Settings Tips Appendix DTS sound is not output. Dolby Atmos, Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output. 0 Check that the digital audio output setting on the connected device is set to “DTS”. 0 Check the digital audio output setting on the connected device. On some devices, “PCM” is set by default. 0 Make HDMI connections. ( v p. 54) DTS Neural:X mode cannot be selected. 0 DTS Neural:X cannot be selected when using the headphones. Dolby Surround mode cannot be selected. 0 Dolby Surround cannot be selected when using the headphones. Audyssey MultEQ ® XT, Audyssey Dynamic EQ ® and Audyssey Dynamic Volume ® cannot be selected.
0 These cannot be selected when you have not performed Audyssey ® Setup. ( v p. 164) 0 Switch to a sound mode other than “Direct”. ( v p. 113) 0 These cannot be selected when using the headphones. “Restorer” cannot be selected. 0 Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS surround, “Restorer” cannot be used. ( v p. 143) 0 Switch to a sound mode other than “Direct”. ( v p. 113) No sound is output when using ZONE2. 0 Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL) cannot be played back. Use analog connections.
0 When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a range of about 30 m. Front panel Display Rear panel 212 Remote Index