Rinse aid system en The consumption values specified are laboratory measurements determ- ined in accordance with the currently applicable standard and using the Eco 50° programme and the factory value of the water hardness is set to 16 - 20°E. 2. Add rinse aid up to the max mark. max Rinse aid system Rinse aid system Rinse aid system Rinse aid 3. If rinse aid spills out, remove it For optimum drying results, use rinse aid. Only use rinse aid for domestic dish- washers. from the tub. Spilled rinse aid can cause ex- cessive frothing during the wash cycle. 4. Close the lid of the dispenser for Adding rinse aid If the rinse aid refill indicator lights up, top up with rinse aid.
Only use rinse aid for domestic dishwashers. rinse aid. a The lid clicks into position. 1. Press the catch on the lid of the dispenser for rinse aid and lift . Setting the amount of rinse aid If there are streaks or water marks on tableware, change the amount of rinse aid. 1. Press . 2. To open the basic settings, press for 3 seconds. a The display shows Hxx. a The display shows . 3. Press repeatedly until the display shows the value set at the factory r04. 4. Press repeatedly until the right amount of rinse aid has been set. – A low setting adds less rinse aid during the wash cycle and re- duces streaking on tableware.
– A higher setting adds more rinse aid during the wash cycle, reduces water marks and im- proves the drying result. 27 2 1